Recently Viewed

INA219 High Side DC Current Sensor Breakout - 26V 3.2A Max

INA219 High Side DC Current Sensor Breakout - 26V 3.2A Max
  Zoom
 INA219 High Side DC Current Sensor Breakout - 26V 3.2A MaxINA219 High Side DC Current Sensor Breakout - 26V 3.2A Max 
Our Price:  £11.12(Inc. 20% VAT)(£9.27 Exc. VAT)Earn 11 Loyalty Points

SKU:  PPADA904
Part Number:  904
Brand:  AdaFruit

Stock / Availability

Available Now:  

No stock, discontinued
Need more than we have? : Supplier out of stock
  (1 Review)

This breakout board will solve all your power-monitoring problems. Instead of struggling with two multimeters, you can just use the handy INA219B chip on this breakout to both measure both the high side voltage and DC current draw over I2C with 1% precision.

Most current-measuring devices such as our current panel meter are only good for low side measuring. That means that unless you want to get a battery involved, you have to stick the measurement resistor between the target ground and true ground. This can cause problems with circuits since electronics tend to not like it when the ground references change and move with varying current draw. This chip is much smarter - it can handle high side current measuring, up to +26VDC, even though it is powered with 3 or 5V. It will also report back that high side voltage, which is great for tracking battery life or solar panels.

A precision amplifier measures the voltage across the 0.1 ohm, 1% sense resistor. Since the amplifier maximum input difference is ±320mV this means it can measure up to ±3.2 Amps. With the internal 12 bit ADC, the resolution at ±3.2A range is 0.8mA. With the internal gain set at the minimum of div8, the max current is ±400mA and the resolution is 0.1mA. Advanced hackers can remove the 0.1 ohm current sense resistor and replace it with their own to change the range (say a 0.01 ohm to measure up 32 Amps with a resolution of 8mA)

We include a 6-pin header (so you can easily attach this sensor to a breadboard) as well as a 3.5mm terminal plug so you can easily attach and detach your load. Usage is simple. Power the sensor itself with 3 to 5VDC and connect the two I2C pins up to your microcontroller. Then connect your target power supply to VIN+ and the load to ground to VIN-. We have an Arduino library right now that will do all the gain, range and math for you - just plug and go! We'll have a more detailed tutorial up shortly.

 


Customers who bought this item also bought:


Customer Reviews
Average Rating (1 Review):  
Write a Review and share your opinions!

Rating:  
Great Gadget
Friday, 6 June 2014  |  Jim

This is a great little gadget. I used it as part of a power supply monitor for my breadboards. Using this breakout, an Arduino Mini and a 1.8" LCD I am now able to monitor supply current as a project developes (especially good for battery operated projec

 

2 of 2 people found this review helpful.

Free Technical Support
Fast Delivery Options
Customer Loyalty Scheme

Proto-PIC - UK Distributor of Sparkfun, Arduino, BBC Micro Bit, Adafruit Electronic ComponentsProto-PIC ; UK Distributor of Sparkfun, Arduino, Adafruit, BBC Micro Bit electrical components