FREE UK Shipping

Orders over £75

Educational

Discounts

FREE Tech Support

Call 01592 572094

ISO 9001 Logo

Proto-PIC Promise

Quality Assured

Sparkfun DEV-13688 MyoWare LED Shield

£23.17 inc VAT (£19.31 ex VAT)

3 in stock

Brand: SparkFun
Part Number: DEV-13688
SKU: PPDEV-13688
Barcode: 845156007585

Sparkfun DEV-13688 MyoWare LED Shield

The MyoWare LED Shield is designed to pair with the MyoWare Muscle Sensor. The blue 10-segment bar graph shows the magnitude of the measured signal. The more muscle activation measured, the higher up the board the lit LEDs will go. With this shield you will be provided with a visual representation of the signals provided by the MyoWare Muscle Sensor and an on-board lithium polymer (LiPo) power source.

This shield is likely to be the top board in a stack, so solder on some 1×3 male headers and plug into the sensor board. The power is supplied on the LED shield, but controlled by the power switch on the sensor. Once the stack is assembled, snap on some electrodes and stick the sensor on the target muscle.

The MyoWare Muscle Sensor to which this shield attaches is an Arduino-powered, all-in-one electromyography (EMG) sensor from Advancer Technologies. The MyoWare board acts by measuring the filtered and rectified electrical activity of a muscle, outputting 0-Vs Volts depending on the amount of activity in the selected muscle, where Vs signifies the voltage of the power source.

Note: The MyoWare Power Shield and the MyoWare LED Shield both provide power, but at slightly different voltages. Don’t use both of these shields at the same time.

Additional information

Brand

Part Number

DEV-13688

SKU

PPDEV-13688

Barcode

845156007585

Reviews

There are no reviews yet.

Be the first to review “Sparkfun DEV-13688 MyoWare LED Shield”

Your email address will not be published. Required fields are marked *