How to Upload Sketches to the ATiny2313
GET CODE for the datasheet which can be used to program other chips.
If you would like to purchase the products in this video, click the associated product.
This video shows you the setup & programming of the ATtiny 2313 Microcontroller from ATMEL. All you need is a breadboard, jumper wires and an Arduino UNO (or older Duemilanove, but a resistor is needed between RESET & 5V after you upload the Arduino as ISP sketch). This principle can be used with other ATtiny chips, as the pin names are: 13 - SCK 12, MISO 11, MOSI 10, TARGET RESET.